Kingston Technology KNS800/WG, KNS500/WG manual Rear Panel, Power Connector, 10/100TX UTP Ports

8 Rear Panel

Rear Panel

Power Connector

12V 1.2A

5 4 3 2 1

10/100TX UTP Ports

Figure 3 – KNS500/WG Rear Panel

Power Connector

5V 3A

8 7 6 5 4 3 2 1

10/100TX UTP Ports

Figure 4 – KNS800/WG Rear Panel

Power Connector

The Fast EtheRx Switch gets its power from the external power adapter. Insert the power jack into the power connector located to the far right. For safety purposes, ONLY use the included power supply for proper operation. The wrong type of power supply may cause damage to both the Fast EtheRx Switch and the power supply. Please note the KNS500/WG and KNS800/WG use different power adapters.

NOTE: The power adapter DC output voltage varies depending on the model type. Be sure to use the correct power adapter. Please refer to “Appendix C Specifications” for the differences in the DC output voltage requirements of the Fast EtheRx Switches. Polarity on the power jack and DC power connector is negative (-) on the outside and positive (+) on the inside.

10/100TX UTP Ports

The Fast EtheRx Switch has either five (5) or eight (8) UTP ports that auto- negotiate 100BASE-TX or 10BASE-T connections and half- or full-duplex mode operation. All ports, like all normal switch ports, are generally configured as MDI-X. However, the last UTP port (port 5 on the KNS500/WG or port 8 on the KNS800/WG) supports both MDI-X and MDI port configuration. Please refer to Cascade Switch on page 6.

Kingston Technology Company KNS800/WG User’s Guide – Rev.B01