Parts supplied for installation:
lbase grille
l miscellaneous parts bag
Check that all parts were included.
To prevent damage to product or floor covering:
l Do Not lower the refrigerator against the shipping base when removing the shipping base.
l Do Not remove protective film until refrigerator is in operating position.
l All four leveling legs must contact the floor to support and stabilize the full weight of the refrigerator.
l Keep cardboard shipping piece or plywood under refrigerator until it is installed in operating position.
1 Remove and save literature
. package and parts bag taped to refrigerator door. Remove four brackets (two on each side) attaching shipping base to refrigerator bottom.
Do Not remove tape and door bracing until product is secured in final location. See Page 3.
L.Place
appliance dolly under refrigerator
side and loosely
wrap dolly
refrigerator.
Injury Hazard
Because of the weight and size of the refrigerator, two or more people are required to install it.
Most of the refrigerator’s weight is at the top. Extra care is needed when moving the refrigerator to prevent tipping.
Failure to follow these instructions could result in injury.
Place sections of shipping carton 3 . on the floor when rolling dolly and refrigerator into the house. Move refrigerator close to
4
Set’power
at top of cabinet to “OFF” position.
Plug power supply cord into grounded outlet. Install retainer on grounded outlet using screw from parts bag.
ld
5 Place top of cardboard
. carton or plywood under refrigerator. Remove dolly. Open appliance doors and remove all boxes, parts packages and packing materials from refrigerator and freezer
compartments. Do Not remove protective film.
Move the refrigerator straight back and evenly into the opening. Check that:
l copper tubing is not kinked.
l power supply cord is on top of refrigerator next to cover.
compression | union | compression |
nut |
| nut |
L | l/4” | 1 |
| (6 mm) |
|
| sleeve |
|
Slide a compression nut and sleeve on open end of each copper line. Use a copper tubing union to connect both copper lines. Do Not
Turn water supply valve to “OPEN” position. Turn refrigerator switch “ON.” Wait a few minutes. Check water line connection and water valve on top of cabinet for leaks. Without kinking the tubing, carefully place it back underneath cabinet.
Insert carton corner posts between strap and refrigerator at side trim pieces and handles. Carefully tighten strap making sure side trim and handles are protected.
Check that water supply line has been flushed. See Page 7.
Pull | copper | line | from refrigerator | ||
6. water | valve | and | copper | line from | |
plumbing | forward | from | underneath | ||
refrigerator. | Remove | cap | from | water line. | |
Page 8
