KitchenAid 2003757 installation instructions Door swing dimensions, Tipping Radius, Anti-tip

Door swing dimensions

Top front of refrigerator

/door		/ I	\	\
	90”‘/		\\
L’	/ /		\	\	door-,

Tipping	radius
			/----------	‘--:	1
Forward/backward		,1-----	1--
tipping	radius	,,--’

IIIIIIIII’ ,’

I’

I’

8’

8’

:

I

v+AW L

Side

tipping radius ,//’

/ / / / / / / /

//I/

I

I

I

Size			A		B
36”	(91	cm)	87-l /4” (222	cm)	90-l /2” (230\			cm)I
42”	(106	cm)	87-l /4” (222	cm)	93”	(236	cm)
48”	(122	cm)	87-l /4” (222	cm)	96”	(244	cm)

Page 4

Location must permit doors to open to 90” min. Allow 1 inch (2.5 cm) min. space between refrigerator side and corner wall.

Anti-tip		requirements
/4”	(6 mm)	ma]	Two,	2”	x 4”		x
	f		32” (5 cm			x
		*lOcmx81				cm)
			anti-tip		wood
		fl	boards
			Attach		to	wall
			studs	with		six,
			#8 x 3” (76 mm)
			(or longer)
			wood	screws.
2”	(5 cm)	_	Boards		must		be
			long	enough			to
1min.
			fully cover
			width	of
			compressor
			cover.

-rear

wall

If boards are placed before installation of refrigerator, locate boards so the bottom surface of the boards are 84 inches (213 cm) from the floor. During installation, raise the refrigerator up so there is l/4 inch (6 mm) maximum between top of refrigerator and bottom of anti-tip boards.

If solid soffit is 1 inch (2.5 cm) above

refrigerator, anti-tip wood boards are not required.

If solid soffit is not available or soffit is more than 1 inch (2.5 cm) above cover, center wood boards on rear wall l/4 inch (6 mm) maximum above refrigerator. Attach wood boards to wall studs with wood screws - making sure that screws are engaged in wall studs 1 -l/2 inch (3.8 cm) minimum and that boards extend 2 inches (5 cm) minimum over the top rear of refrigerator compressor cover.