If range does not
operate...
•Check that the circuit breaker is not tripped or the house fuse blown.
•Check that the power supply cord is plugged into the wall receptacle.
•Check that the gas supply is on.
•Check that the regulator shutoff valve is in the “OPEN” position.
For cleaning and
maintenance...
If removing the range is ever necessary for cleaning or maintenance, shut off gas supply to range. Disconnect the gas and electrical supply.
If the gas or electrical supply is inaccessible, lift the range slightly at the front and pull the range out away from the wall. Pull the range out only as far as necessary to disconnect the gas and electrical supply lines.
Remove the range to complete cleaning or maintenance.
Move range back into operating position. Remove drawer. Level the range. Connect gas line to range and check for leaks. Plug in range or reconnect power. Make sure that left rear leveling leg is engaged in the
If you need assistance...
The KitchenAid Consumer Assistance Center will answer any questions about operating or maintaining your range not covered in the Installation Instructions. The KitchenAid Customer Interaction Center is open 24 hours a day, 7 days a week. Just dial
When you call, you will need the range model number and serial number. Both numbers can be found on the model/serial rating plate located on the oven frame behind the oven drawer.
If you need service...
In the event that your KitchenAid appliance should need service, call the dealer from whom you purchased the appliance or a
— Major — Service and Repair.”
You can also obtain the service company’s name and telephone number by dialing, free, within the continental United States, the KitchenAid Consumer Assistance Center telephone number,
Maintain the quality built into your KitchenAid appliance
— call a
Moving the range...
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Connect
Reconnect the
Failure to follow these instructions can result in death or serious burns to children and adults.
When moving range, slide range onto cardboard or hardboard to prevent damaging the floor covering.
If removing the range is necessary for cleaning or maintenance:
1.Remove the storage drawer.
2.Shut off the gas supply to the range.
3.Slide range forward, away from the wall, just far enough to disconnect the gas and electric supply lines.
4.Slide range forward to complete cleaning or maintenance.
range foot
5.Making sure the
•Look for the
•Slide range back so rear range foot is under
6.Check that range is level.
7.Reconnect gas line to range and check for leaks.
8.Plug in range or reconnect power.
9.Reinstall storage drawer.
Part No. 9758639
© 2004 KitchenAid.
® Registered Trademark of KitchenAid, U.S.A.
HOME APPLIANCES
| Printed in U.S.A. |
Prepared by KitchenAid, Benton Harbor, Michigan 49022 | 03/2004 |