Choose attachment option
WARNING
Excessive Weight Hazard
Use two or more people to move and install dishwasher. Failure to do so can result in back or other injury.
Using two or more people, stand the dishwasher up.
5.Push bracket into slot on the side of dishwasher, and bend tab in towards the side of the dishwasher so that it keeps the bracket in place.
NOTE: Do not attach the dishwasher, this will be done later.
bend tabs 
Option 1: Countertop attachment
The dishwasher must be |
| |
secured to the cabinet. There | brackets | |
are two brackets on top of the | ||
| ||
dishwasher that can be |
| |
attached to the countertop if it |
| |
is wood, laminate or other |
| |
similar surfaces. If this is not |
| |
possible, the brackets may be |
| |
moved to the sides of the |
| |
dishwasher. |
|
NOTE: Do not attach the dishwasher, this will be done later.
Option 2: Dishwasher side attachment
front vent
model shown
Move dishwasher into cabinet opening
1.Grasp the sides of the dishwasher
at the edges of the door panel.
2. | Tilt dishwasher backwards on | ||
| wheels and move dishwasher close | ||
| to cabinet opening. Do not push on | ||
| the front of the panel or on the | ||
| |||
|
| ||
3. | If dishwasher has a power supply |
|
|
| cord, insert power supply cord into hole cut into | ||
| cabinet. | ||
| If using direct wire, check that it is on the right front | ||
| side of opening. | ||
4. | Check that water line is on the left side of opening and | ||
| drain hose is near the center of the hole in the cabinet. | ||
5. | Slowly move dishwasher completely into cabinet | ||
(for marble, granite or other hard surface countertop)
1.To remove the brackets from the top, flatten tab at back of brackets with pliers, and pull the brackets out of the slots.
tabs
2.Break off the end of the bracket along the scored line.
score line
3.Open dishwasher door and place towel over pump assembly and spray arm of dishwasher. This will prevent screws from falling into pump area when securing dishwasher to cabinet.
4.Push the plastic buttons out of the side of the tub.
NOTE: Save the buttons to cover the holes after dishwasher is installed.
plastic button
opening. Do not kink or pinch copper tubing, drain |
hose, power supply cord or direct wire between |
dishwasher and cabinet. |
Helpful Tip: Once the dishwasher is in position, you |
may have to support the front of the dishwasher by |
raising, lowering or shimming front feet. |
6. Remove cardboard from under dishwasher. |
NOTE: It is all right if dishwasher fits tightly into cabinet opening. Do not remove insulation blanket
14
