KitchenAid 9759536B Attach Backguard or Island Trim, Wire Cable from Home Power Supply, A B C D

4-Wire Cable from Home Power Supply

IMPORTANT: Use the 4-wire cable from home power supply where local codes do not permit connecting to a 3-wire system.

Attach Backguard or Island Trim

WARNING

A

B

C

D

A. Cable from home power supply B. Black wires

C. Red wires

D. 4-wire flexible cable from range E. Junction box

E

F

G

H

I

F. White wires

G. UL listed wire connectors H. Green (or bare) ground wires

I. UL listed or CSA approved conduit connector

Excessive Weight Hazard

Use two or more people to move and install range. Failure to do so can result in back or other injury.

1.Using 2 or more people, move range close to cabinet opening.

2.Remove cardboard or hardboard from under range. Move range into its final position.

3.Attach the backguard or island trim as required for your installation. See “Tools and Parts.” Attachment screws are included in the package containing literature.

Attaching the Backguard

A

1.Connect the 2 black wires (B) together using a UL listed wire connector.

2.Connect the 2 red wires (C) together using a UL listed wire connector.

3.Connect the 2 white wires (F) together using a UL listed wire connector.

4.Connect the green (or bare) ground wire (H) from the range cable to the green (or bare) ground wire (in the junction box) using a UL listed wire connector.

5.Install junction box cover.

3-Wire Cable from Home Power Supply

IMPORTANT: Use the 3-wire cable from home power supply where local codes permit a 3-wire connection.

A
B
C	G
	H

D

E

I

F

A. Cable from home power supply	F. 4-wire flexible cable from
B. Junction box	range
C. Black wires	G. Red wires
D. White wires	H. UL listed wire connectors
E. Green (or bare) ground wire	I. UL listed or CSA approved
(from range)	conduit connector

1.Connect the 2 black wires (C) together using a UL listed wire connector.

2.Connect the 2 white wires (D) and the green (or bare) ground wire (E) (of the range cable) using a UL listed wire connector.

3.Connect the 2 red wires (G) together using a UL listed wire connector.

4.Install junction box cover.

A. Three front screws (4 rear screws required but not shown)

Attaching the Island Trim

A

A. Center hole not used

4.Using 2 or more people, tip the range back so that the front feet lift off the ground. Slide range toward the wall until the rear brace is under the anti-tip bracket. Stand range up, making sure the anti-tip bracket catches the rear brace.

10