KitchenAid 9759536B Install Anti-Tip Bracket, Make Electrical Connection - U.S.A. Only, A C B D

Install Anti-Tip Bracket

WARNING

Tip Over Hazard

A child or adult can tip the range and be killed.

Connect anti-tip bracket to wall behind range.

Reconnect the anti-tip bracket, if the range is moved.

Failure to follow these instructions can result in death or serious burns to children and adults.

1.Choose the correct anti-tip bracket for your installation.

■If the wall behind the range has no baseboard or has a baseboard up to ³⁄₈" (0.95 cm) thick, use the shorter 1" (2.5 cm) anti-tip bracket.

■If the wall behind the range has a baseboard thicker than ³⁄₈" (0.95 cm), use the longer 1¾" (4.4 cm) anti-tip bracket.

2.Locate a stud on the wall behind the range. Measure the distance from top of rear brace to floor.

A

C

B

D

A. Rear brace

B. Top of rear brace to floor

C. Top of rear brace

D.Floor

3.Add ⁵⁄₁₆" (0.79 cm) to the measurement from Step 2. This will allow anti-tip bracket to slide over rear brace.

4.Using the final measurement from Step 3, measure from the floor up and mark a horizontal line on the wall where a wall stud is located.

A

B

D

C

A. Horizontal line marked from Step 4.

B. Wall stud

C. Mounting screws

D. Anti-tip bracket

5.Position top of anti-tip bracket at line marked in Step 4 and mark holes. Drill two ¹⁄₈" holes at the positions marked on the wall. Use screws provided to fasten anti-tip bracket to wall.

Anti-tip bracket must be mounted securely to stud in wall behind the range. Depending on thickness of the wall, longer screws may be required. Longer screws are available from your local hardware store.

Make Electrical Connection - U.S.A. Only

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Use 8 gauge solid copper wire.

Electrically ground range.

Failure to follow these instructions can result in death, fire, or electrical shock.

This range must be connected to a grounded, metallic permanent wiring system or a ground connector should be connected to the ground terminal or wire lead on the range.

This range is manufactured with a cabinet-connected, green (or bare) ground wire. Connect the range cable to the junction box through the UL listed or CSA approved conduit connector.

1.Disconnect power.

2.Remove junction box cover if present.

3.Install a UL listed or CSA approved conduit connector to the junction box.

A

A. UL listed or CSA approved conduit connector

4.Route the flexible cable conduit from the range to the junction box using a UL listed or CSA approved conduit connector.

5.Tighten screws on conduit connector.

6.See “Electrical Connection Options Chart” to complete installation for your type of electrical connection.

Electrical Connection Options Chart

If your home has:	Go to Section:
4-wire	4-Wire Cable from Home
	Power Supply
	½"
	(1.3 cm)
3-wire	3-Wire Cable from Home
	Power Supply
	½"
	(1.3 cm)

9