KitchenAid KBSU487TSS Outdoor Grill Care, Changing the Light Bulb, GeneralCleaning

OUTDOOR GRILL CARE

Changing the Light Bulb

1.Unplug grill or disconnect power.

2.To remove glass light cover, remove screw and gently pry downward with a small flat-blade screwdriver at the left side of the cover, and pull away from the retainers.

A

BB

A.Screw

B.Retainers

3.Remove bulb from socket.

4.Replace bulb with a new 12-volt, 25-watt maximum, halogen bulb, using a tissue or wearing cotton gloves to handle the bulb. To avoid damaging the bulb, do not touch the bulb with bare fingers.

5.Replace glass light cover by placing sides of the lens into the bulb retainers in the light housing and tightening the screw.

6.Plug in grill or reconnect power.

GeneralCleaning

IMPORTANT: Before cleaning, make sure all controls are off and the grill is cool. Always follow label instructions on cleaning products.

For routine cleaning, wash with soap and water using a soft cloth or sponge. Rinse with clean water and dry at once with a soft, lint-free cloth to avoid spots and streaks.

Do not use steel wool to clean the grill, as it will scratch the surface.

Use vinyl grill cover, available from your local dealer, to shelter finish from weather. See “Assistance or Service” section.

STAINLESS STEEL

IMPORTANT: To avoid damage to stainless steel surfaces, do not use soap-filled scouring pads, abrasive cleaners, Cooktop Polishing Creme, steel wool, gritty wash cloths or paper towels.

Cleaners should not contain chlorine. Damage may occur.

Food spills should be cleaned as soon as entire grill is cool. Spills may cause permanent discoloration.

Cleaning Method:

■Rub in direction of grain to avoid scratching or damaging the surface.

■KitchenAid® Stainless Steel Cleaner and Polish Part Number

4396920 (not included):

See “Assistance or Service” section to order.

■Liquid detergent or all-purpose cleaner:

Rinse with clean water and dry with soft, lint-free cloth.

■Vinegar to remove hard water spots.

■Glass cleaner to remove fingerprints.

GRILL GRATES

IMPORTANT: To avoid damage to grill grates, do not use a steel or fiber scraper. Immediately after you are finished cooking, loosen food soil with a brass bristle brush. Turn all burners to HI for 10-15 minutes with the hood closed to burn off food soil. Turn off all burners, raise the hood and let grates cool. Use the brass bristle brush to remove ash from the grill grates.

When completely cool, grill racks can be removed for thorough cleaning. Clean them with a mild detergent and warm water.

For baked-on soil, prepare a solution of 1 cup (250 mL) ammonia to 1 gal. (3.75 L) water. Soak grates for 20 minutes, then rinse with water and dry completely.

WARMING SHELF

Cleaning Method:

■Liquid detergent or an all-purpose cleaner.

■Rinse with clean water and dry with soft, lint-free cloth.

■For tough spots or baked-on grease, use Heavy Duty Degreaser Part Number 31552, a commercial degreaser designed for stainless steel.

See “Assistance or Service” section to order.

EXTERIOR

IMPORTANT: Make sure gas supply is off and all control knobs are in the OFF position. Make sure the side burner is cool.

The quality of this material resists most stains and pitting, providing that the surface is kept clean, covered and polished.

■For tough spots or baked-on grease, use Heavy Duty Degreaser Part Number 31552, a commercial degreaser designed for stainless steel.

See “Assistance or Service” section to order.

■Cleaning should always be followed by rinsing with clean warm water.

■Wipe the surface completely dry with a soft cloth.

■Apply polish to all stainless steel non-cooking areas after each cleaning to avoid permanent damage to surface.

INTERIOR

Discoloration of stainless steel on these parts is to be expected, due to intense heat from the burners. Always rub in the direction of the grain. Cleaning should always be followed by rinsing with clean, warm water.

Cleaning Method:

■Liquid detergent or all-purpose cleaner or for small, difficult- to-clean areas, use Heavy Duty Degreaser Part Number 31552, a commercial degreaser designed for stainless steel. See “Assistance or Service” section to order.

■A heavy-duty scrub sponge can be used with mild cleaning products.

■Rinse with clean water and dry completely with a soft, lint- free cloth.

20