KitchenAid KBSU487TSS Installation Requirements, Tools and Parts, Location Requirements

INSTALLATION REQUIREMENTS

Tools and Parts

Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.

Tools Needed

■	Tape measure	■	Wrench or pliers
■	Small, flat-blade screwdriver	■	Pipe wrench
■	Flat-blade screwdriver	■	Scissors or cutting pliers
■ #2 and #3 Phillips screwdriver			(to remove tiedowns)
			Noncorrosive
■	Level	■
			leak-detection solution

Parts Needed

■Gas line shutoff valve

■½" male pipe thread nipple for connection to pressure regulator

■Pipe-joint compound resistant to LP gas

■CSA design-certified outdoor flexible stainless steel appliance connector (4-5 ft [1.2-1.5 m]) or rigid gas supply line as needed.

Parts Supplied

■Convertible regulator set for 4" WCP Natural gas.

■1 single-prong plug/500 mAmp transformer assembly, on some models

■1 single-prong plug/5,000 mAmp transformer assembly

Additional Parts Supplied (on some models)

■1.5-volt “D” size alkaline battery

■Rotisserie motor mounting bracket

■Rotisserie motor

■Rotisserie forks

■Rotisserie spit

■Smoker box

Location Requirements

WARNING

Explosion Hazard

Do not store fuel tank in a garage or indoors.

Do not store grill with fuel tank in a garage or indoors.

Failure to follow these instructions can result in death, explosion, or fire.

WARNING

Fire Hazard

Do not use grill near combustible materials.

Do not store combustible materials near grill.

Doing so can result in death or fire.

Select a location that provides minimum exposure to wind and traffic paths. The location should be away from strong draft areas.

Do not obstruct flow of combustion and ventilation air.

Clearance to combustible construction for built-in and freestanding outdoor grills:

■A minimum of 24" (58.0 cm) must be maintained between the front of the grill hood, sides and back of the grill and any combustible construction.

■A zero clearance may be maintained on the insulated jacket surface to combustible construction.

Rotisserie

A 6" (15.2 cm) minimum clearance is needed for the rotisserie motor.

A grounded, 3-prong outlet located to the left of the grill is required. See “Electrical Requirements” section.

5