![](/images/new-backgrounds/1062652/626529x1.webp)
green | green | black | white |
ground | ground | wire | wire |
white screw | wires | (from | (from |
wires |
| blower) | blower) |
|
|
| |
connector |
|
|
|
blower speed
blower motor
lightswitch switch
switch
black |
| brown wire | |
| (from hood | ||
wires |
| ||
| liner) | ||
|
| ||
|
| blue wire | |
|
| (from hood | |
|
| liner) | |
|
| exterior | |
| power | blower | |
hood liner | wiring | ||
supply | |||
wiring | cable |
|
Connect both green ground wires (from exterior blower motor and from
•Connect
•Connect
Exterior blower motor wiring:
•Connect the black blower motor wire to the blue hood liner wire with a
•Connect white blower motor wire to brown hood liner wire with a
13.
14. Replace wiring box cover. Tighten screw securely.
15. Connect exterior blower vent system to hood liner collar. Seal joint with duct tape to make airtight.
16. Reconnect power.
17. Check operation of hood liner and exterior blower.
Lights:
•Move the light switch to “1” position. Lights should go on. Move switch back to “0” position. Lights should go off.
Exterior blower motor and speed control:
•Move motor switch to “1” position. Exterior blower motor should turn on.
•Move speed control switch to vary the blower speed from low (at the left) to high (at the right).
•Move speed control switch back to low (at the left). Move the motor switch back to “0”and the blower motor should turn off.
18. Reinstall filters. Place back edge of filter into channel at rear of hood liner. Push filter up while pushing tab back. When filter is in place, release tab. Locking pin will hold filter in place. Repeat with other filter(s).
19. Install front enclosure.
To get the most efficient use from
your new hood liner, read the “Use and Care Information” section. Keep your KitchenAid Installation Instructions and Use and Care Guide close to hood liner for easy reference.
5