4-18

REMOVING THE MAIN CONTROL BOARD ASSEMBLY
NOTE: Sharp edges may be present.
1. Unplug the refrigerator or disconnect the
power.
2. Pull the refrigerator out of its mounting
location.
3. At the rear of the unit, remove the hex-
head screws from the unit compartment
cover and remove the cover.
Electrical Shock Hazard
Disconnect power before servicing.
Replace all panels before operating.
Failure to do so can result in death or
electrical shock.
Main Control
Board Assembly
4. Remove the inverter assembly (see page
4-17 for the procedure).
5. Disconnect the 3-, 9-, and 12-pin connec-
tors, as shown below.
6. Remove the hex-head screw from the
green ground wire.
7. Remove the two hex-head mounting
screws from the main control board enclo-
sure and remove it from the unit.
8. Disconnect the six connectors from the
main control board.
Ground Wire Main Control Board Assembly
Screws
3-, 9-, & 12 Pin Connectors
Four Connectors
Two Connectors