4-8
7. Disconnect the nut on the reservoir inlet
tubing coming from the water valve, and
slide the nut off the end of the tubing.
8. Pull the ends of the water reservoir tubing
through the condenser fan motor bracket.
9. Remove the crisper and bottom shelves
from the refrigerator compartment.
10. Remove the hex-head screw from the
water reservoir tubing strap.
11. Pull the ends of the water reservoir tubing
through the grommet.
Water Valve
Pull Tubing
Through Here
Water Reservoir Inlet Tubing Nut
REASSEMBLY NOTE: Make sure that you
route the water reservoir tubing through the
condenser fan motor bracket to the water valve
and the water dispenser union (see the bottom
left photo). Do not allow the tubing to contact
the hot discharge lines coming from the com-
pressor.
Tubing Strap
Pull Tubing Up Through Grommet
Condenser Fan Motor Bracket
5. Pull the unit out of its mounting location so
you can access the unit compartment
cover.
6. At the rear of the unit, remove the hex-
head screws from the unit compartment
cover and remove the cover.
Unit Compartment Cover