4-21
9. Disconnect the water dispenser fill tube
from the union, slide the nut off the end of
the tube, and allow the water to drain into
the container.
10. If possible, pull the water dispenser fill
tube through the wire tie, or cut the tie.
5. Disconnect the three wire connectors and
the green ground wire from the switch
subpanel.
6. Remove the two hex-head screws from
the switch subpanel and remove the panel.
3 Wire Connectors & Ground Wire
Screw Screw
Switch Subpanel
8. Place a container near the base grille to
catch the water in the next step.
11. At the dispenser, pull the water dispenser
fill tube out of the dispenser hole.
12. Remove the water dispenser fill tube
bracket from the end of the old fill tube and
install it on the end of the new tube. Leave
approximately 1″ of tubing for the spout.
Wire Tie
Water Dispenser Fill Tube Nut
Spout = 1″
Fill Tube Bracket
7. Open the refrigerator and freezer doors
and remove the two screws from the base
grille and remove the grille from the front of
the unit.
Base Grille
Screw Screw