Condenser
A dirty or clogged condenser:
■Obstructs proper airflow.
■Reduces ice making capacity.
■Causes higher than recommended operating temperatures which may lead to component failure.
WARNING
Electrical Shock Hazard
Disconnect power before cleaning.
Replace all parts and panels before operating.
Failure to do so can result in death or electrical shock.
1.Unplug ice maker or disconnect power.
2.Using a Phillips screwdriver, remove the two screws in the lower access panel and the two screws from the base grille area of the front panel support.
3.Pull out on the base grille then pull down on the panel to remove.
4.Remove dirt and lint from the condenser fins and the unit compartment with a brush attachment on a vacuum cleaner.
5.Replace the lower access panel using the two screws.
6.Plug in ice maker or reconnect power.
Interior Components
1.Unplug ice maker or disconnect power.
2.Open the storage bin door and remove any ice that is in the bin.
A
B
C
D
A.Separators
B.Water Tank
C.Slope
D.Shaft
3.Remove the slope by bending it in the center and releasing it from the shafts.
4.Remove the water tank, and drain the water.
5.Remove the separators by lifting each separator up and pushing back.
6.Lift off the ice chute from the rear and front frames.
A
B
A. Frame Pipe
B. Ice Chute
7.Below the ice chute is the spray assembly. Pull the discharge tube from the spray assembly and pull the assembly toward you.
A 
B 
C 
A. Discharge tube
B. Frame pipe
C. Spray assembly
8
