Remove Warming orStorageDrawer, Level Range

Remove Warming orStorageDrawer

Remove the warming or storage drawer to gain access to the lower section of the range. This will be necessary for some of the following installation steps.

To Remove Warming Drawer:

1.Open drawer to its fully open position.

2.Locate the black loops on both sides of the drawer.

A. Loop

3.Pull both loops forward at the same time, then pull drawer out another inch.

4.Holding the drawer by its sides, not its front, gently pull it all the way out.

To Remove Storage Drawer:

1.Pull drawer straight out to the first stop.

2.Lift up the back of the drawer and pull out.

Verify Anti-Tip BracketLocation

IMPORTANT: On models with a warming drawer, the rear range foot must be viewed from the front and slightly to one side of the range.

1.To check that the anti-tip bracket is installed, use a flashlight and look underneath the bottom of the range.

■Look for the anti-tip bracket securely attached to floor.

■Slide range back so rear range foot is under anti-tip bracket.

3.If range is not level, pull range forward until rear leveling leg is removed from the anti-tip bracket.

Use a wrench or pliers to adjust leveling legs up or down until the range is level. Push range back into position. Check that rear leveling leg is engaged in the anti-tip bracket.

NOTE: Range must be level for satisfactory baking performance.

Make Gas Connection

WARNING

Explosion Hazard

Use a new CSA International approved gas supply line.

Install a shut-off valve.

Securely tighten all gas connections.

If connected to LP, have a qualified person make sure gas pressure does not exceed 14" (36 cm) water column.

Examples of a qualified person include:

licensed heating personnel,

authorized gas company personnel, and authorized service personnel.

Failure to do so can result in death, explosion, or fire.

Typical rigid pipe connection

A combination of pipe fittings must be used to connect the range to the existing gas line. Your connections may be different, according to the supply line type, size and location.

1.Apply pipe-joint compound made for use with LP gas to all pipe thread connections.

2.Using a pipe wrench to tighten, connect the gas supply to the range.

Level Range

1.Place rack in oven.

2.Place level on rack and check levelness of the range, first side to side; then front to back.

A. Gas pressure regulator

B. 90° elbow (must have ½" male pipe thread)

C.Nipple

D.Union

E.Black iron pipe

I H

F. Manual gas shutoff valve G. ½" or ¾" gas pipe

H.Nipple

I.Union

J.90° elbow

W10118262B specifications

The KitchenAid W10118262B is a highly regarded essential for modern kitchens, designed to enhance both functionality and style. This versatile and efficient appliance is part of KitchenAid's commitment to quality and innovation, making it a must-have for home chefs and baking enthusiasts alike.

One of the standout features of the W10118262B is its impressive capacity. With adequate room to accommodate various dishes, it seamlessly handles everything from batch baking to meal prepping for larger gatherings. This spacious design reduces the need for multiple cooking sessions, allowing users to save time and energy.

The appliance boasts advanced heating technologies that ensure even and consistent cooking results. Combined with its powerful heating elements, the W10118262B is capable of achieving precise temperature control, which is crucial for achieving that perfectly baked soufflé or evenly roasted chicken. This level of control is facilitated by an intuitive digital interface, offering users the ability to select and monitor temperature settings with ease.

Another notable characteristic of the W10118262B is its array of built-in cooking modes. It features multiple options that cater to different methods, such as baking, broiling, and steaming. This multifunctionality not only broadens the culinary possibilities but also allows for creativity in the kitchen. Additionally, the appliance is equipped with smart features, enabling connectivity that can be controlled via mobile devices, making it easier to manage cooking processes from anywhere in the home.

Cleaning the KitchenAid W10118262B is made simple due to its removable components and non-stick surfaces. This thoughtful design plays a vital role in maintaining hygiene and convenience, essential in any busy kitchen.

Lastly, the sleek and modern aesthetic of the W10118262B complements any kitchen decor, enhancing its overall look while providing practicality. It is available in various color options, allowing users to choose one that best fits their style.

In summary, the KitchenAid W10118262B is an exemplary kitchen appliance, combining ample capacity, advanced cooking technology, versatile modes, and an appealing design. It stands as a testament to KitchenAid's dedication to helping home chefs elevate their culinary experience. Whether for daily cooking or special occasions, this appliance is sure to deliver on performance and style.

KitchenAid W10118262B Remove Warming orStorageDrawer, Verify Anti-Tip BracketLocation

Models: W10118262B