CUSTOM PANEL INSTALLATION INSTRUCTIONS
Custom Drawer Panels
If you plan to install a custom wood panels, you will need to create the panels yourself or consult a qualified cabinetmaker or carpenter. See dimension drawings for panel specifications.
IMPORTANT:
■The thickness of the custom panel must be ¹⁄₂" (12.7 mm) to ³⁄₄" (19.05 mm).
■Do not exceed the height dimension for the custom panel(s). Panel(s) that exceed the height dimension may damage the drawer dishwasher, cabinets or countertop.
■The width of the custom panel(s) may vary according to the width of the cabinet opening.
Custom Panel Dimensions
Upper drawer panel
23⁷⁄₁₆"
(59.5 cm)
16¹⁄₄"
(41.3 cm)
³⁄₄"
(1.9 cm)
Lower drawer panel
Preparing Custom Panels
1.Lay the custom panels (top and bottom) face down on a clean, soft work surface.
2.Using a pencil, mark the centerpoints for the 2 panel fastener pilot holes and 6 pilot holes needed for the upper panel.
| 11¹⁄₄" | A | 11¹⁄₄" |
|
2¹⁄₂" | (28.5 cm) |
| (28.5 cm) | 1¹⁄₂" |
8¹⁄₈" |
| 8¹⁄₈" | ||
(6.3 cm) |
| (3.8 cm) | ||
(20.7 cm) |
| (20.7 cm) | ||
|
| 8" | ||
|
|
|
| |
|
|
| B | (20.2 cm) |
|
|
|
| |
|
|
| C | 14¹⁄₈" |
|
|
|
| (36.6 cm) |
A. Center line
B. Panel fastener pilot holes (2)
C. Pilot holes (6)
3.Mark the centerpoints for the 2 panel fastener pilot holes and 4 pilot holes need for the lower panel.
| 11¹⁄₄" | A | 11¹⁄₄" |
|
|
|
| ||
2¹⁄₂" | (28.5 cm) |
| (28.5 cm) | 1¹⁄₂" |
8¹⁄₈" |
| 8¹⁄₈" | ||
| (3.8 cm) | |||
(6.3 cm) |
| |||
(20.7 cm) |
| (20.7 cm) |
| |
|
|
|
³⁄₄"
(1.9 cm)
23⁷⁄₁₆"
(59.5 cm)
12³⁄₄"
(61 cm)
| 10¹⁄₂" | |
B | (26.7 cm | |
C |
|
|
|
| |
A. Center line
B. Panel fastener pilot holes (2)
C. Pilot holes (4)
Hardware Installation | 4. Using a ¹⁄₈" drill, drill each hole ³⁄₈" (1cm) deep. |
Center the hardware (left to right) onto the custom panel. When installing the hardware, be sure that the mounting screws are flush with the back of the custom panel(s).
³⁄₈" (2 cm)
IMPORTANT: To avoid drilling through to the front of the custom panel, do not drill deeper than ³⁄₈" (1 cm).
16
