INSTALLATION REQUIREMENTS
Tools and Parts | |
Gather the required tools and parts before starting installation. | Parts Supplied |
Read and follow the instructions provided with any tools listed | Check that all parts are included. | |
here. | ||
|
Tools needed
■ | Pliers |
■ | Phillips screwdriver |
■ | |
■ ³⁄₁₆" and ¼" nut drivers or | |
| hex sockets |
■ | 10" adjustable wrench |
■ | Utility knife |
■ | Level |
■ | Electric drill |
A 
BC D
■ | Measuring tape or ruler |
■ | 1½" hole saw bit |
■ | ¹⁄₈" drill bit |
■ | Security |
| driver (if installing custom |
| front panels) |
EF 
Parts needed
B
A 
C
I
G
H
J |
K
L
M 
D
E
A. 72" (182.9 cm) flexible water supply line B. Zip tie
C. Appropriate sized UL listed wire connectors (2) D. Handle (if installing custom front panels)
E. Custom panel (if installing custom front panels)
A. ³⁄₄" UL listed strain relief B. 1.25" hose clamp
C. Mounting bracket screws (8) D. Unit mounting screws (4)
E. Y drain connector
F. Mounting brackets (4)
G. Drain connector spring clamps (2)
H. Trim strips (2)
I. Toe kick brackets (2)
J. Toe kick bracket screws (2) K. Toe kick trim
L. Panel fasteners (on some models [2])
M. TORX®† screws (on some models [10])
†®TORX is a registered trademark of Acument Intellectual Properties, LLC
Location Requirements
IMPORTANT: Observe all governing codes and ordinances. Failure to meet codes and ordinances could lead to fire or electrical shock.
Proper installation is your responsibility.
■Contact a qualified installer to ensure that the dishwasher is installed to meet all electrical and plumbing national and local codes and ordinances.
■Install the dishwasher as specified in these instructions.
■Have everything you need to properly install dishwasher.
■Keep the dishwasher and water lines leading to dishwasher from freezing. Damage from freezing is not covered by the warranty.
■This dishwasher is manufactured for indoor use only.
■Install and level dishwasher on a floor that will hold the weight, and in an area suitable for its size and use.
4
