KitchenAid W10440541A Electrical Connection U.S.A. Only, Power Supply Cord, Direct Wire

4.Drill two ¹⁄₈" (3 mm) holes that correspond to the bracket holes of the determined mounting method. See the following illustrations.

Floor Mounting

5.Using a Phillips screwdriver, mount the anti-tip bracket to the wall or floor with two #12 x 1⁵⁄₈" screws provided.

6.Move the range close enough to the opening to allow for final gas and electrical connections. Remove the shipping base, cardboard or hardboard from under the range.

7.Move the range into its final location, making sure the rear leveling leg slides into the anti-tip bracket.

Rear position	Front position	Diagonal (2 options)	8. Move the range forward onto shipping base, cardboard or
Wall Mounting			hardboard to continue installing the range using the following
			installation instructions.

Electrical Connection - U.S.A. Only

Power Supply Cord

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Use a new 40 amp power supply cord.

Plug into a grounded outlet.

Failure to follow these instructions can result in death, fire, or electrical shock.

Direct Wire

WARNING

Electrical Shock Hazard

Disconnect power before servicing.

Use 8 gauge copper or 6 gauge aluminum wire.

Electrically ground range.

Failure to follow these instructions can result in death, fire, or electrical shock.

1.Disconnect power.

2.Remove the terminal block cover screws located on the back of the range. Pull cover down and toward you to remove cover.

3.Remove plastic tag holding three 10-32 hex nuts from the middle post of the terminal block.

A

A.Hold-down screws

B.Terminal block cover

B

4. Add strain relief.

10