Level Range
1.Place a rack in oven.
2.Place level on rack and check levelness of range, first side to side; then front to back.
3.If range is not level, pull range forward until rear leveling leg is removed from the
Use a wrench or pliers to adjust leveling legs up or down until the range is level. Push range back into position. Check that rear leveling leg is engaged in the
NOTE: Range must be level for satisfactory baking performance.
4.Replace the storage drawer:
■Fit the ends of the drawer rails into the guides in the cavity.
■Slide the drawer closed.
Complete Installation
1.Check that all parts are now installed. If there is an extra part, go back through the steps to see which step was skipped.
2.Check that you have all of your tools.
3.Dispose of/recycle all packaging materials.
4.Check that the range is level. See the “Level Range” section.
5.Use a mild solution of liquid household cleaner and warm water to remove waxy residue caused by shipping material. Dry thoroughly with a soft cloth. For more information, read the “Range Care” section of the Use and Care Guide.
6.Read the “Range Use” section in the range Use and Care Guide.
7.Plug in range or reconnect power.
8.Turn on surface burners and oven. See the Use and Care Guide for specific instruction on range operation.
If range does not operate, check the following:
■Household fuse is intact and tight; or circuit breaker has not tripped.
■Range is plugged into an outlet.
■Electrical supply is connected.
■See the “Troubleshooting” section in the Use and Care Guide.
When the range has been on for 5 minutes, check for heat. If range is cold, turn off the range and contact a qualified technician.
Moving the Range
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install
Slide range back so rear range foot is engaged in the slot of the
Do not operate range without
Failure to follow these instructions can result in death or serious burns to children and adults.
When moving range, slide range onto cardboard or hardboard to avoid damaging the floor covering.
If removing the range is necessary for cleaning or maintenance:
For power supply cord-connected ranges:
1.Using two or more people, slide range onto cardboard or hardboard to perform cleaning or maintenance.
2.Unplug the power supply cord.
3.Perform cleaning or maintenance.
4.Plug in range.
5.Check that
■Look for the
■Slide range back so rear range foot is under
6.Check that range is level.
16
