M6 501P Operation – Pro Logic Mode
Pro Logic Mode
power
mute
balance delay prologic
field |
| EQ on/off | EQ setup |
preset | 1 | preset 2 | preset 3 |
Your M6 501P will automatically switch to Pro Logic mode when it detects the Pro Logic signal. With other signal inputs you can select the Dolby Pro Logic mode by pressing Prologic Button on the remote. Repeatedly pressing the Prologic Button will cycle the Pro Logic mode in the order of: “AUTO”, “ALL PCM”, “ENABLE” and “DISABLE ”.
If a Pro Logic signal is detected the M6 501P will switch to Pro Logic mode automatically and
the following information is displayed:
D o l b y D i g i t a I C o
P R O L O G I C A耟 U T O
If a Stereo signal (either in analog or in digital form) is detected the M6 501P will switch to
Stereo mode automatically. You can then convert the stereo signal to Pro Logic mode by
pressing thePrologic Button until the display reads as follows:
D | o | l | b y | D i | g i t | a | I | C o | |
P R O L O G I | C A L L P C M | ||||||||
|
|
|
|
|
|
|
|
| |
|
|
|
|
| or |
|
|
| |
|
|
|
|
|
|
|
| ||
D | o | l | b y | D i | g i t a | I | C o | ||
P R O L O G I | C E N A B L E |
In the case of converting a Pro Logic or
the Prologic Button until the display reads as follows:
D o l b y D i g i t a I C o
P R O L O G I C D I S A B L E
22