![REFERENCE SERIES](/images/new-backgrounds/12791/127913x1.webp)
REFERENCE SERIES
IMPORTANT SAFETY INSTRUCTIONS
1.READ these instructions.
2.KEEP these instructions.
3.HEED all warnings.
4.FOLLOW all instructions.
5.DO NOT use this apparatus near water .
6.CLEAN ONLY with dry cloth.
7.DO NOT block any ventilation openings.Install in accordance with the manufacturer's instructions.
8.DO NOT install near any heat sources such as radiators,heat registers,stoves,or other apparatus (including amplifiers) that produce heat.
9.DO NOT defeat the safety purpose of the polarized or grounding type plug. A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wider blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet.
10.PROTECT the power cord from being walked on or pinched,particularly at plugs,conve- nience receptacles,and the point where they exit from the apparatus.
11.ONLY USE attachments/accessories specified by the manufacturer.
12.USE only with a cart,stand,tripod,bracket,or table specified by the manufacturer, or sold with the apparatus.When a cart is used,use caution when moving the cart/apparatus combination to avoid injury from
13.UNPLUG this apparatus during lightning storms or when unused for long periods of time.
14.REFER all servicing to qualified service personnel.Servicing is required when the apparatus has been damaged in any wa y, such as
This symbol indicates that there are important operating and maintenance instructions in the literature accompanying this unit.
This symbol indicates that dangerous voltage constituting a risk of electric shock is present within this unit.
UNPACKING AND ASSEMBLING THE SPEAKER
NOTE: Although this loudspeaker can be unpacked and set up by a single person,a helper will make the job easier, not to mention safer, for speaker and owner alike.
The easiest way to remove the speaker from its carton is to turn the open end of the box down so that it is resting on the floor, with the flaps spread out and away. Then pull the box straight up and off.Remove any packing material from the speaker and grille,place it back in the carton, and store in case you ever need to ship the loudspeaker. Locate the speaker’s four stabilizing feet and retaining screws,which are needed for the next step.
If the speaker is not already standing on its head,carefully turn it over so that the bottom is fac- ing up.Near the corners are threaded inserts for attaching the feet.For each one,take one of the supplied feet and align it so that its screw hole is over the insert.Thread one of the supplied screws through and tighten it firmly with a
Figure 1
Once the feet are attached,install either a carpet spike or a rubber tipped bolt into the threaded insert in each foot.The best sonic performance on carpeted surfaces will be achieved by using the supplied spikes.Then,carefully turn the speaker right side up.Once installed,the speaker must be lifted when moved to avoid carpet damage.The spikes are sharp; keep your feet clear!
WARNING: To reduce the risk of fire or electrical shock,do not expose this apparatus to rain or moisture.
RISKOFELECTRICSHOCK |
DONOTOPEN |
WARNING: Voltages in this equipment are hazardous to life.No
CAUTION: Changes or modifications not expressly approved by the manufacturer could void the user’s authority to operate this device.
ABOUT YOUR KLIPSCH PURCHASE
Thank you for your purchase of Klipsch floorstanding loudspeakers.After reading this manual and connecting your system,you will hear the result of over 55 years of stringent engineering and
Align the magnetic posts on the inside of the grille with the screws on the front of the speaker, and it will snap into place.
PLACEMENT
Although your Reference Series speakers will perform well in a wide variety of locations,you will get the most out of them by following some simple guidelines:
•The speakers require a few inches of clearance behind them to allow their ports to breathe,and they will sound best when they are at least two feet (60 centimeters) from any nearby walls.
•If possible,arrange both speakers so that they are equal distances from the floor and the wall behind them.It can also help to have the left and right speakers at different distances from their nearest side walls.This sort of staggering helps smooth the bass range.
•Any speaker’s bass output and response is strongly influenced by its distance from room boundaries, such as walls and the floor. Moving a speaker closer to a room boundary will increase its bass output, while moving it away will reduce the bass. Following the suggestions above will typically yield good results with Klipsch Reference Series floorstanding speakers, but you may find that you can