Kobe Range Hoods CH2236SQ, CH2230SQ manual Under The Cabinet Installation Rear Vent

UNDER THE CABINET INSTALLATION ￿ REAR VENT

Preparation before installation

NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING.

-Decide the location of the venting pipe from the hood to the outside. Refe

-A straight, short venting run will allow the hood to perform more efficient

-Try to avoid as many transitions, elbows, and long run as possible. This the performance of the hood.

-Temporarily wire the hood to test for proper operation before installing.

-Peel protective film off the hood (if any).

-For installing under the cabinet with recessed bottom, attach 4-inch wide w strips (not included) on each side. Refer to Figure 7.

-Measure and create access opening for electrical wires under the cabinet or opening for the electrical wires at the rear of the hood.

-Remove the screws on the vent cover (rear) and cut along the line of the in cover (rear) opening. Refer to Figure 8.

-Cut the vent cover (rear) opening and reverse to the other side. Refer to Reattach the vent cover (rear).

Figure 6

Inner Vent	Reversed
	Cover (Rear)

Figure 8

Hood Installation

CAUTION: If required to move the cooking range to install the hood, turn off the p electric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.

8