Kobe Range Hoods CH2230SQ, CH2236SQ manual Stand Alone Installation Rear Vent

STAND ALONE INSTALLATION ￿ REAR VENT

***This installation only applied with the purchase of a duct cover (Model No. CH1

Preparation before Installation

NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING.

-Decide the location of the venting pipe from the hood to the outside. Refe

-A straight, short venting run will allow the hood to perform more efficientl

-Try to avoid as many transitions, elbows, and long run as possible. This ma the performance of the hood.

-Use duct tape to seal the joints between pipe sections.

-If necessary, prepare back wall frame with cross framing lumber for secure i Using references on Table 2 and measurements on page 21-22, decide the level lumber. Refer to Figure 22.

Hood Preparation before Installation

-Temporarily wire the hood to test for proper operation before installing.

-Peel protective film off the hood and the duct cover (if any).

-Remove the screws on the vent cover (rear) and cut along the line of the inn cover (rear) opening. Refer to Figure 23.

-Cut the vent cover (rear) opening and reverse to the other side. Refer to Fi

Figure 21

Inner Vent

Cover (Rear)

Figure 23

13