Kobe Range Hoods CH2230SQ manual Connect electrical wires. Refer to Wiring to Power Supply on page

-If necessary, attach two rubber stands (provided) withscrewst o (provided)4x8 mm) to the back of the hood.

-Attach the hood-mounting bracket to the back of the hood with nine (3/16￿ x screws (provided) as shown in Figure 16.

Hood Installation

CAUTION: If required to move the cooking range to install the hood, turn off the p electric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.

1.Using references on Table 2 and measurements on page 21-22, mark the leveling of the hood. Position two mounting screws (not provided) on the wall, leaving from the wall as shown in Figure 17.

Mounting

Screws

Figure 16

2.Align hood-mounting bracket to the two screws on the wall and hook hood into p Tighten screws to secure hood to the wall. CAUTION: MAKE SURE THE HOOD IS SECURE BEFORE RELEASING.

Duct Cover Installation

3.Mark the position of the duct cover-mounting bracket. EUsefromreferenceTable 2 and measurements on page 21-22. Attach and secure duct cover-mounting bracket wit screws (not provided). Refer to Figure 18. NOTE: Inner duct cover will cover cover-mounting bracket.

4.Use aluminum or steel pipe to connect the plastic exhaust on the hood to the d above. Use duct tape to make all joints secure and air tight.

5.Connect electrical wires. Refer to ￿Wiring to Power Supply￿ on page 16.

6.Slide the inner duct cover up 2 inches before sliding the entire duct cover on Refer to Figure 19.

11