Kobe Range Hoods CH2236SQ, CH2230SQ manual Under The Cabinet Installation Top Vent

UNDER THE CABINET INSTALLATION ￿ TOP VENT

Preparation before Installation

NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING.

-Decide the location of the venting pipe from the hood to the outside. Refe

-A straight, short venting run will allow the hood to perform more efficient

-Try to avoid as many transitions, elbows, and long run as possible. This the performance of the hood.

-Temporarily wire the hood to test for proper operation before installing.

-Peel protective film off the hood (if any).

-For installing under the cabinet with recessed bottom, attach 4-inch wide wo strips (not included) on each side. Refer to Figure 2.

-Measure and create access opening for electrical wires under the cabinet.

-Cut the multi duct exhaust according to the size of the venting pipe. Refer

Figure 1

6￿ Round Vent 7￿ Round Vent

Hood Installation

CAUTION: If required to move the cooking range to install the hood, turn off the p electric range at the main electrical box. SHUT OFF THE GAS BEFORE MOVING A GAS RANGE.

1.Puncture the knockout holes on the hood as shown in Figure 4. 6