3.Mark the position of the duct
4.Use aluminum or steel pipe to connect the plastic exhaust on the hood to the ductwork above. Use duct tape to make all joints secure and air tight.
5.Connect electrical wires. Refer to “Wiring to Power Supply” on Page 17.
6.Slide the inner duct cover up 2 inches before sliding the entire duct cover onto the hood. Refer to Figure 19.
Figure 18
Figure 19
7.Adjust the height of the inner duct cover to the duct
Figure 20
8.Fasten outer duct cover to multi vent exhaust on the hood with four (4x8 mm) screws (provided).
13