WALL MOUNT INSTALLATION – TOP VENT
***This installation only applied with the purchase of a duct cover.
Preparation before Installation
NOTE: TO AVOID DAMAGE TO YOUR HOOD, PREVENT DEBRIS FROM ENTERING THE VENT OPENING.
-Decide the location of the venting pipe from the hood to the outside. Refer to Figure 13.
-A straight, short venting run will allow the hood to perform more efficiently.
-Try to avoid as many transitions, elbows, and long run as possible. This may reduce the performance of the hood.
-Use duct tape to seal the joints between pipe sections.
-If necessary, prepare back wall frame with cross framing lumber for secure installation.
-Using references on Table 2 and measurements on Page
Hood Preparation before Installation
-
-
-
Temporarily wire the hood to test for proper operation before installing. Peel protective film off the hood and the duct cover (if any).
Cut the multi vent exhaust according to the size of the venting pipe. Refer to Figure 15.
Figure 13 | Figure 14 |
6" Round Vent | 7" Round Vent | |
|
|
|
|
| Figure 15 |
| 11 |
|
