Kobe Range Hoods CX1842GS-8 manual

Ductwork Installation

19.Use 7” round aluminum or steel pipe to connect the plastic damper on the hood to the ductwork above.

20.Use duct tape to make all joints secure and air tight. Make sure pipe is in the groove of the plastic damper. Refer to Figure 14.

Figure 14

Duct Cover Installation

21.(SKIP STEP 22 and 23 IF USING THE RECIRCULATING CONVERSION KIT. YOU WILL NOT NEED THE DUCT COVER-MOUNTING BRACKET.) Using references in Table 1 and measurements on page 14, mark the leveling point for duct cover-mounting bracket.

22.Secure the duct cover-mounting bracket to the wall with two screws (not provided). Refer to Figure 15. Make sure all screws are tightened.

23.Hook the inner duct cover onto the duct cover-mounting bracket and release the outer duct cover to fit onto the hood as shown in Figure 15 and 16.

Figure 15

Figure 16

Final Assembly

24.Rotate the oil container clockwise to install it. Shown in Figure 17.

25.Turn power ON in control panel. Check all lights and fan operation.

26.Make sure to leave this manual for the homeowner.

Figure 17