To Clean Carbon Filter (Optional Recirculating Kit)
1)Turn oil container
2)Use a Philips screwdriver to take out the screws (2 pcs). Shown in Figure 19.
Figure 18 | Figure 19 |
|
3)Remove the carbon filter from the two stainless steel filters. Shown in Figure 20.
4)Place carbon filter into warm water with neutral detergent and clean thoroughly. Dry and replace.
5)
Figure 20
To Replace Light Bulb
CAUTION: HALOGEN LIGHT UNIT MAY BE HOT! WAIT UNTIL UNIT IS COOL.
NOTE: DO NOT TOUCH HALOGEN LIGHT WITH BARE HANDS, WHICH MIGHT CAUSE OVER HEAT AND SHORTEN THE LIFT OF LIGHT BULBS.
|
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
1.Make sure all controls are OFF, and range hood is unplugged.
2.Place the
3.Gently separate glass covering from the housing .
4.Gently pull out the defective light bulb and discard. Light bulbs should be 12V 20W maximum.
5.Wear a glove or use a cloth to hold the new light bulb and push securely into light socket. NOTE:
DO NOT PUSH TOO HARD OR YOU MAY BREAK THE BULB CONNECTOR.
6.Put back halogen light glass cover .
7.Plug back power cord and turn on range hood to test for operation.
12
