Kodak 7 manual Installation environment Power source

Installation environment

Power source

Select the proper environment for using the printer to obtain the optimum service from your printer. It should NOT be placed in a location:

—which is exposed to direct sunlight.

—which is in the direct air stream of a cooler, heater, or ventilator.

—where the temperature and the humidity are extremely high or low. The room temperature should be 10–35°C (50–95°F) and humidity should be 15–85% RH.

—which does not have a stable, level floor.

—which could easily get wet.

—which has poor ventilation and where ammonia gas might be generated.

—which is far from a power supply.

NOTE: Please contact your service representative when you need to move the printer to another place.

Before connecting the power cord of the printer to the outlet, check the following items:

—Only connect to a dedicated electrical socket-outlet.

—Use the printer in a place which is near an electrical outlet

and where there is little voltage fluctuation. (The power supply voltage should be specified voltage ± 10% for imaging

and +10% or -15% for feeding. The power supply frequency should be specified ± 1 Hz.)

—Do not plug the power cord into a multi-socket extension cord.

—At frequent intervals, check to see that the power plug is not abnormally hot, that there are not any cracks or scrapes on the cord, and that the power plug is fully inserted into the socket.

—Be sure to use an outlet made for a 3-pin plug.

A-62032 November 1996 B-3