Setting Up the Printer

Label/wrapper

5.Remove the label/wrapper from the ribbon.

Take-up spool

6.Push the right side of the take-up spool into the rear spool holder on the right.

7.Place the left side of the take-up spool into the rear spool holder on the

left.

8. Rotate the take-up spool until it locks into place.

9.If there is any slack in the ribbon, remove it by turning the take-up spool.

IMPORTANT: Slack in the ribbon can cause a paper jam when making prints.

Installing the Print Catcher

The print catcher collects finished prints as they exit the printer.

• Set the print catcher into the printer as shown.

Print catcher

1-7

Page 11
Image 11
Kodak 9810 manual Installing the Print Catcher