Cleaning the imaging guides
3. Wipe the upper and lower transport areas with a roller cleaning pad.
4.Dry the transport area with a dry Staticide Wipe.
5.Push against the raised edge on the left side of the rear roller cover and pull the cover up and out to remove it.
Rear drive roller cover
6.Remove any dust or debris under the rear drive roller cover.
7.
8.Go to the next section to clean the imaging guides.
Clean the exposed (top side) surfaces of the imaging guides. You do not need to remove the imaging guides for cleaning unless there is dust or dirt on the underside of the imaging guide. If you need to remove the imaging guides, follow the instructions for “Installing the Kodak Imaging Guide Set for i100 Series Scanners”.
1. Wipe the upper and lower imaging guides with a Staticide Wipe.
2.Dry the imaging guides with a dry Staticide Wipe.
3.Lower the scanner door and press it down firmly until it latches into place.
4.Go to the next section to clean the paper path.
25 |
