USING KODAK CONTROL STRIPS / PROCESS RA-4 / EXTENDED LENGTH IN THE FUJI FRONTIER DIGITAL MINILAB
KODAK Control Strips, Process RA-4 / Extended Length, CAT No.130 4690, are designed for use in all Control Strip Holders for FUJI FRONTIER and NORITSU 3501F and 3701F Digital Minilabs. No shim is required when using these extended length strips. If you have installed a shim in your control strip magazine for using the standard length KODAK Control Strips, Process RA-4,, please remove it before using the strips. Use these strips for the most accurate process monitoring when you process KODAK EKTACOLOR ROYAL and KODAK EKTACOLOR EDGE Papers.
For calculating the aims for your control strip code, read the Status A Red, Green, and Blue densities of the reference strip, and then apply the correction factors. For the HD-LD parameter, subtract the corrected LD from the corrected HD density readings. You will find three sets of correction factors on the reference envelop for you to use in calculating the aims. Make sure you select the correct PC 111 correction factors for the specific FUJI FRONTIER or NORITSU “F” Model Digital Minilabs you are using:
For FRONTIER Models 330, 350. 355, 370, 375, and 390, using Process CP-48S, use the correction factors labeled: EKTACOLOR PC11148S
For FRONTIER Model 340, and NORITSU models 3701/02/03/04F using Process CP-49E, use the correction factors labeled: EKTACOLOR PC11149E
For the FRONTIER Models 550, 570, or NORITSU Model 3501/02F and 3705F, using Process CP-49E, use the correction factors labeled:
EKTACOLOR PC111495
