Kodak i100 Series manual Enable scanning, Initiate polling, Feed documents, Disable scanning

Enable scanning	The host must issue a Scan command to enable scanning before
	documents can be transported through the scanner. If scanning has
	not been enabled, the feeder and transport system will not turn on.
Initiate polling	Initiate host system polling of the scanner to ensure scanned
	document images are transferred from the image buffer to the host
	system. Polling should continue until scanning is disabled.
	For more information see the sections entitled, “Controlling
	image transfer order” and “Image header information” later in this
	chapter.
Feed documents	Feed documents according to the instructions found in the Kodak
	i100 Series Scanners, User's Guide.
Disable scanning	Scanning is disabled to allow the host to download configuration/
	setup changes between jobs and to handle certain types of errors.
	Scanning is also disabled when one of the following conditions
	occur:
	• The scanner is first powered on using the power switch.
	• A 1394 bus device Reset command is executed.
	• A scanner-unique End-of-Job command is issued by the host
	computer.
	• Transport timeout is set to End-of-Job.
	• An error occurs requiring fault recovery.
	NOTE: When scanning is disabled, documents cannot be scanned
	until the host enables scanning.

A-61517 October 2004 2-3