V600UserGuide.book Page 20 Tuesday, March 21, 2000 8:26 AM
KODAK V600 Digital Projector and KODAK V600 Zoom Digital Projector
Maintenance
Changing the Lamp Module
Important:The lamp in the KODAK V600 Digital Projector and the KODAK V600 Zoom Digital Projector contains trace amounts of mercury. Some governments require special disposal of lamps containing mercury. Dispose of lamps in accordance with the law and any applicable local regulations.
The lamp module should be replaced with a certified replacement part. To order a new lamp, contact your local dealer of KODAK products or visit our Web site at www.kodak.com/go/projectors
After you have changed the lamp module, make sure that you reset the lamp counter. See “To reset lamp hours” on page 17.
Warning: When replacing the lamp, be sure to turn off the power and unplug the power cord. To avoid burns, wait 30 minutes before opening the lamp module door.
Warning: When you open the lamp module door, be careful to not touch the hot surfaces inside.
Warning: Do not loosen or remove any screws other than those on the lamp module door and the lamp module. Doing so may result in electric shock.
To replace the lamp module:
1.Turn off the projector and let the projector cool for at least 30 minutes.
The fan continues to run after the projector has been turned off.
2.Unplug the power cord from the projector.
3.Turn the projector upside down. With a flat head screw driver, loosen but do not remove the slotted screw in the lamp module door.
20
