Kohler K-1191-RC, K1191-R, K1191-LC manual Using Your Bath, Fill the Bath, Operating Sequence

Chromatherapy

Lights

13. Using Your Bath

Fill the Bath

NOTE: Please read these steps carefully before you operate your bath.

NOTE: The water temperature in the bath should not exceed 104° F (40° C) or the heater will not operate.

IMPORTANT! Like any other bath, prevent ¯ooding the area around the unit by entering the ®lled bathing well slowly. This will allow the system to properly drain excess water.

Fill the unit 4º (10.2cm) to 6º (15.2cm) from the bathing well rim.

Operating Sequence

Press the ″On/Off″ control switch to start the pump/motor and begin operation.

A green light in the ″On/Off″ control switch will turn on to indicate the start of the operating mode. The light will remain green while the unit is running.

Verify that the indicator light for the heater is on when the unit is in operation. This indicator light is located on the underside of the heater box, and is near the sub¯oor at the pump end of the unit.

If the light is not on when the unit is running, press the reset button located to the right of the indicator light on the heater box.

Press the ªOn/Offº control switch again to turn off the bath. The ªOn/Offº control switch will turn off to indicate the end of the operating mode.

NOTE: A built-in timer automatically stops the bath after approximately 20 minutes of operation.

1012493-2-A 12 Kohler Co.