Kohler K1191-LC, K-1191-RC manual Important Product Information, Product Notices Product Inspection

Important Information

WARNING: When using electrical products, basic precautions should always be followed, including the following:

DANGER: Risk of electric shock. Connect only to a circuit protected by a Ground-Fault Circuit-Interrupter (GFCI).

WARNING: Risk of electric shock. A licensed electrician should make all electrical connections.

WARNING: Risk of electrical shock. Disconnect power before servicing.

WARNING: Risk of injury or property damage. Please read all instructions thoroughly before beginning installation, including the following requirements.

NOTICE: Follow all local plumbing and electrical codes.

Install to permit access for servicing.

A green lead wire is provided within the wiring compartment. To reduce the risk of electrical shock, connect this wire to the grounding terminal of your electric service or supply panel with copper wire equivalent in size to the circuit conductor supplying this equipment.

A pressure wire connector is provided on the exterior of the pump or control within this unit to permit connection of a bonding conductor between this unit and all other exposed metal in the vicinity, as needed to comply with local requirements.

Grounding is required. The unit should be installed by a quali®ed service representative, and grounded.

Building materials and wiring should be routed away from the pump body and other heat-producing components of the unit.

Important Product Information

Product Notices

WARNING: Unauthorized modi®cation may cause unsafe operation and poor performance of the effervescent bath. Do not relocate the pump, or make other modi®cations to the over¯owing bath system, as this could adversely affect the performance and safe operation. Kohler Co. shall not be liable under its warranty or otherwise for personal injury or damage caused by any such unauthorized modi®cation.

Product Inspection

Carefully unpack the product, and inspect the unit for damage. Return the unit to the carton during construction to prevent damage.

NOTICE: Make sure the union connections to the pump and in-line heater are securely tightened. Do not overtighten.

Factory-Assembled Features

Factory installed components include pump, in-line heater, submerged chromatherapy lights, control and switch. The pump and piping are factory-assembled.

Connections and Service Access

NOTICE: Provide unrestricted service access to the pump. Provide unrestricted service access to the pump, in-line heater, and control box. You must construct an access panel to provide sufficient clearance for servicing the pump, in-line heater, and control box. The access panel must be located immediately next to the pump and in-line heater. Study the roughing-in information.

1012493-2-A 2 Kohler Co.