Kohler K-1375 manual Chromatherapy Operation if Equipped, Care and Cleaning Instructions

Operating Your Bath (cont.)

Observe that, when the bath drains below the level sensors, the automatic two-minute purge cycle occurs. The air system operates at a low speed to blow any residual water out of the air channels.

Observe that, about 60 seconds after shutdown, all user keypad lights extinguish.

Initiating a Manual Purge Cycle

After stopping the air system and draining the bath, rotate the ring on the user keypad to the purge icon.

Observe that the purge cycle icon is flashing blue.

Press the ″OK″ button once.

The purge icon flashes green and the mode is implemented. The air system operates at a low speed to blow any residual water out of the air channels.

After about two minutes, the air system stops automatically.

Chromatherapy Operation (if Equipped)

NOTE: Chromatherapy may be used with all modes of operation. Chromatherapy may also be used when the air system is not operating.

Chromatherapy Cycle - When this mode is activated, the chromatherapy lights automatically and continuously cycle through the eight colors: white, violet, indigo blue, aqua blue, green, yellow, orange, and red. One cycle through all eight colors takes about one minute. Rotate the outer ring to select this mode and press “OK” to activate it. To turn off the lights, press the “OK” button while the chromatherapy mode is selected and active.

Chromatherapy Specific Color Selection - When this mode is activated, you may choose a specific color for the bath. Rotate the outer ring to select this mode, press the “OK” button, and use the up/down buttons to reach the desired color. To turn off the lights, press the “OK” button while the chromatherapy mode is selected and active.

Care and Cleaning Instructions

Do not use powdered cleaners unless the cleaner is fully dissolved in water. Solid substances could block the airjets.

Do not use full strength bleach or ammonia cleaning solutions. Chemically active cleaning solutions can damage the bath surface.

Do not use abrasive cleansers or solvents on acrylic surfaces. Abrasive cleaners and solvents can damage the bath surface.

Wipe out your acrylic bath with a soft cloth after each use.

Avoid detergents, disinfectants, or cleaning products in aerosol cans.

NOTE: To restore dull or scratched units: Apply white automotive polishing compound with a clean rag. Rub scratches and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste wax. Do not wax areas where you walk or stand.

Cleaning Your User Keypad and Remote Control

Use a soft cloth to wipe the keypad and remote control after each use. If the surface becomes dirty, use a non-abrasive soap and warm water to clean.

Maintaining the Airjets

If cleaning the airjets is required due to hard water deposits, use a small between-the-teeth dental brush and white vinegar. Dip the brush in the vinegar, brush the hole, rinse the brush in clean water, and then use the wet rinsed brush to rinse the hole.

1038265-5-B 8 Kohler Co.