Remove the Jets
Insert the tool hook as shown and pull the jet out of the housing. The jet should be facing up when this is done.
Troubleshooting Procedures
Remove the Jets
Reinstall the Jets
Housing
Inspect and lubricate the O-ring.
Slide the O-ring onto the first shoulder of the jet.
Insert the jet into the housing, and lightly push and rotate until it snaps in position.
NOTE: A special tool is provided with the jets that will allow you to remove them from the whirlpool. This tool is also supplied with each trim kit.
Position the jet ball nozzle so it is pointing upward.
NOTE: The nozzle must remain pointed up or the tool will slip off.
Insert the removal tool, hooked end up, into the opening of the jet and hook the inside top of the nozzle.
Grasp the tool firmly and place your thumb against the whirlpool wall. Pull steadily on the tool until the jet assembly pulls free of the hole. Be careful not to lose the
Reinstall the Jets
NOTE: The jet
Install the
Carefully insert the jet into the housing, and lightly push and rotate the jet until it snaps into position. Do not force the jet.
NOTE: When installed correctly, the jet should turn smoothly both clockwise and counterclockwise.
Troubleshooting Guide
This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or qualified electrician should correct any electrical problems. For warranty service, contact your dealer or wholesale distributor.
Troubleshooting the Whirlpool System
Symptoms | Probable Causes | Recommended Action |
1. User keypad does not | A. No power to control. | A. Check wiring and connect power. If |
illuminate when power |
| problem persists, refer to |
button is pressed or outer |
| installer/dealer. |
ring is rotated. |
|
|
|
|
|
Kohler Co. | 9 |
