Kohler K-865 manual Operating Your Whirlpool, Neckjet Operation

Turn the jet trim ring clockwise to decrease the flow.

Fill with water at least 2" (5.1 cm) above the highest jet.

Position the jet nozzles to direct

the water flow as

desired.

Turn the jet trim ring counterclockwise to increase the flow.

Operating Your Whirlpool

Turn the jet trim fully counterclockwise. Position the jet nozzles so they face down toward the basin.

NOTE: The water temperature in the whirlpool should never exceed 104°F (40°C). A built-in heater automatically maintains the water temperature when the whirlpool is running, as long as the water temperature does not exceed 104°F (40°C). The heater will disengage at higher temperatures.

Close the drain, and fill the whirlpool to a level at least 2″ (5.1 cm) above the top of the highest jet. Use your hand to test the water temperature for comfort and safety, then carefully enter the bath.

Press Power to turn on the whirlpool. The whirlpool will start at medium volume. The heater will also turn on and the heater icon will illuminate.

Increase or decrease the water flow by pressing the up or down arrows on the keypad. An indicator bar in the center of the keypad shows the water flow volume.

Adjust the jets for optimum air/water mixture. Turn the jet trim clockwise to reduce the flow, and counterclockwise to increase the flow. Position the jet nozzles to direct the water flow as desired to maximize your hydro-massage experience.

The heater turns on automatically when the whirlpool is operating, and turns off when the pump motor is turned off. The heater may be turned off, through the keypad, at anytime while the pump is operating.

Press Power a second time to turn off the whirlpool.

NOTE: Your whirlpool will automatically stop after approximately 20 minutes of continuous operation. You can restart the whirlpool, if you desire, by pressing Power.

Carefully exit the bath, and open the drain to empty the whirlpool.

NOTE: Consult the ″Troubleshooting″ section of this manual before calling a qualified service representative.

Neckjet Operation

Make sure the slip cover is in place on the pillow, and the pillow is attached to the neckjet body.

With the whirlpool operating, rotate the outer ring until the neckjet mode is flashing. Press ″OK″ to activate the neckjets. The neckjet pulsing action will start at medium speed.

To increase or decrease the neckjet pulsing action, press either the up or down arrows on the keypad.

Kohler Co. 5 1019451-5-C