Kohler K-922/K-923 manual Install the Spout - Wall Installation, 10.2 cm, Intake, Pipe, Kohler Co

3/8" (1 cm)

Valve Outlet Tubing

1x3

Pipe Strap

4"

(10.2 cm)

Intake	2x4
Pipe

Spout

Assembly

7-5/8"

(19.4 cm)

4. Install the Spout – Wall Installation

Install a 2x4 for spout support so it lays flush against the top support of the drip tray. If the drip tray is installed, the spout center must be 7-5/8″ (19.4 cm) from the drip tray mounting studs. If the drip tray is not installed, the spout center must be 14-16″ (35.6-40.6 cm) from the deck of the bathing fixture.

NOTE: When 2x6 wall studs are present, the front of the 2x4 must be flush with the front of the wall stud.

Install a 1x3 so it is 4″ (10.2 cm) above the 2x4 and inset 3/8″ (1 cm) from the back of the studs. The larger side of the 1x3 must face outward.

NOTE: When 2x6 wall studs are present, install the 1x3 so it is 2-3/8″ (6 cm) from the back of the wall stud.

Place the spout assembly into position. Verify that the spout and drip tray mounting plate (if installed) are centered.

Remove the boot cap from the end of the intake pipe.

Remove the mounting sleeve and cartridge.

Kohler Co. 7 1006741-2-G