ACTIVATE SLEEP FUNCTION [ » SLEEP « ]
You can set a time of between 90 and 10 minutes, after which the device switches itself off.
•To activate a
•To set a shorter
•To switch off the Sleep function, press the SLEEP button - repeatedly until the display @ no longer shows SLEEP.
RADIO
ATTACHING AERIAL
If you use the wire aerial for FM reception:
•The wire must be fully wound out
•Determine the best position by trial and error
•Attach the wire aerial to the wall if necessary using a strip of adhesive tape.
For MW reception, place the device in the best position for the
OPERATING THE RADIO/ SELECT BAND (FM/MW)
01) Select * TUNER (=Radio) using the device selector button.
02) Select between FM (VHF) and AM (medium wave) using the BAND SELECTOR button _.
AUTOMATIC STATION SEARCH / MANUAL SEARCH
| In an automatic search the frequency is increased or deceased until a station of adequate reception strength is found. | |||
01) | Hold down the Forward button ) or | Reverse button 8 for about 1 second – the search starts and stops automatically. | ||
02) | To start the search again, hold down the | Forward button ) or Reverse button 8 again for about 1 second. | ||
| You can use the manual station search for fine adjustment or when the frequency of the station is known. | |||
01) | Press the | Forward button ) or | Reverse button 8 briefly to increase or decrease the frequency in small steps. | |
02) | Keep the | Forward button ) or | Reverse button 8 pressed until you are close to the frequency you require. |
STORE STATION [ » MEMORY « ]
The Designer Audio Unit KH 2300 can store up to 40 stations (20 FM / 20 AM).
01) You set up the desired station by following the instructions relating to "Automatic station search/manual station search" described above.
02) Press the
03) Press the
SELECT STORED STATION
Press the
CD PLAYER
DANGER! The CD player uses a weak but sharply focussed laser beam to scan the surface of the CD. If the device is used improperly then this light can be dangerous to the eyes - never open the case.
INSERTING A CD
01) To open the CD compartment ! pull the top edge towards the front.
02) Insert the CD with the playing side facing towards the device. If you have done this correctly, you should be looking at the printed side. The CD must be placed securely on the central pin.
03) Close CD compartment !.
04) Select the CD player with the device selector button * CD. The display @ shows the total playing time and the number of tracks. NOTE: When you insert a CD, if the display does not show the number of tracks and the total playing time then the CD is possibly the wrong way round or dirty. Clean the CD with a CD cleaning cloth or insert the CD correctly and check the display again.
13