Using the microphone
During the telephone call you will hear the caller via the speaker connected to the car radio.
•For optimal transmitting of your voice place the microphone unit close to you.
•Attach the microphone unit, for example, to the dashboard. For this purpose you can use the supplied sticky tape. In this case clean before- hand dust and grease from the surface. The sticky tape can be used for securing on almost all smooth surfaces.
Operation
Call accept/end
With an incoming call you hear the call signal via your mobile telephone, whilst in the car radio's dis- play is shown the call number.
•You accept an incoming call by pressing the TALK button on the microphone unit or the ACCEPT 
button on the remote control and/or on the front panel.
•You end the telephone call by pressing the TALK button on the microphone unit again or by pres-
sing the END 
button.
Rejecting a call
•With an incoming call press, for longer than 2 seconds, the TALK button on the microphone
unit or press the END 
button to reject the call.
To call
•Press the ACCEPT 
button on the remote control. A blinking cursor appears in the car radio's dis- play.
•With the number buttons enter the telephone number that you want to call.
•Press the ACCEPT 
button again.
The number will be dialed.
Redial
•Hold down the TALK button on the microphone
unit or the ACCEPT 
button on the remote con- trol and/or on the front panel for approx. 2 se- conds.
-If no call number was previously selected via the remote control's number buttons REDIAL appears briefly in the display and then the last number dialed from the mobile telephone will be dialed.
-If one or more call numbers were already dialed via the remote control's number buttons REDIAL appears in the display.
Turn the multi controller or press the
Press the ACCEPT 
button to dial the selected tele- phone number.
Select the entry REDIAL and then press the END 
button to end redial.
Audio streaming (A2DP)
Your car radio uses the A2DP profile (Advanced Audio Distribution Profile) and therefore can play- back your mobile telephone's audio data.
• Select an audio file from your mobile telephone and start the playback.
The entry A2DP appears in the car radio's display and the audio file will playback via the car radio's speaker.
Note
On the mobile telephone it may possibly be necessary to switch playback via the Bluetooth stereo headset.
For this read also, without fail, the operating in- structions for your mobile telephone.
With a few mobile telephones the car radio does not automatically switch to the A2DP mode. In this case you switch to the A2DP mode by pressing the MD/LD button several times until the notice A2DP appears in the dis- play.
- 18 -
