Note:

The yarn must lie correctly between the two discs of the thread tension selector.

Thread tension selector q w

Thread routing on from the thread guide plate 8

further thread routing

3.Guide the yarn, as shown, from front to back through the eyes of the needles.

4.Pull the end of the thread about 10 cm (4“ ) out from the eyes of the needles. Lift the sewing foot o and slide the thread under it; then lower the sewing foot o back down. The lever for lifting and lowering the sewing foot o is located at the rear of the machine, above the sewing lever rod system.

Position the lever to lift the sewing foot o

Trial run

When yarn has been threaded for the first time, or after a yarn breakage it must be rethreaded, proceed as follows:

Lift the sewing foot o.

Hold the ends of the threads between the fingertips of your left hand, slowly turn the handwheel 6 two or three times towards yourself and then check the threads once again.

- 9 -

Page 11
Image 11
Kompernass KH 4300 manual Trial run, Position the lever to lift the sewing foot o