Preparing the tool for use / Cleaning and Maintenance / Disposal
Hard screw bed:
jParticularly high torques can occur, for example with metal screws tightened by socket tool bits. Select a lower rotation speed.
Soft screw bed:
jYou should also select a low speed in order not to damage the wood workpiece surface through contact with the metal screw head. Use a coun- tersinker.
When drilling into wood, metal and other materials, take note of the following advice:
jWith small diameter drill bits use a high drill speed. For large diameter drill bits, use a low drill speed.
jFor hard materials, select a low drill speed. For soft materials, select a high drill speed.
jSecure or fix down the workpiece (if possible) in a clamp or vice.
jMark the intended position of the hole with a centre punch or a nail and select a low drill speed for drilling.
jTake the rotating drill bit out of the hole frequently so that swarf or drill dust can be
Drilling in metal:
jUse a metal drill bit (HSS). For the best results, you should cool the bit with oil. Metal drill bits can also be used to drill into plastic.
Drilling in stone:
jUse a circular shafted masonry drill bit with a hardened metal tip.
Drilling in wood:
jNormally you should use a wood drill with a centring point. For deep holes, use an auger type bit. For large diameter holes, use a forstner bit. You can screw small screws into soft wood without the need for
QCleaning and Maintenance
mCAUTION! Place the direction of rotation switch 3 into the middle position before carry- ing out any tasks on the device, e.g. changing tools or maintenance, or before transporting or storing the device. Inadvertent operation of the ON / OFF switch 4 may result in injury.
Pull the mains lead out of the mains socket every time and remove the battery before you clean or maintain the device.
The Cordless Drill / Screwdriver is
jAlways keep the device clean, dry and free of oil or grease.
jClean the device immediately after you have finished using it.
jDo not allow any liquids to enter the device. Use a cloth to clean the housing. Never use petrol, solvents or cleaning agents that might attack plastic.
QDisposal
The packaging comprises exclusively en-
Do not dispose of electrical appliances with your domestic waste!
According to the European Directive 2002 / 96 / EG, concerning used electrical and electronic appliances and its implementation in national law, superannu- ated electrical appliances must be collected and
disposed of via an environmentally suitable recy- cling facility.
Defective or worn out rechargeable batteries must be recycled according to Directive 91 / 157 / EEC. In this regard, read the special safety notices for charging stations and battery packs.
GB/IE/CY
13
