Before first use/ Preparing the tool for use
QTorque pre-selection
You can adjust the torque by using 9 torque pre- selection. The torque levels regulate a range of up to ca. 8 Nm.
When the value of the torque setting is reached, the clutch disengages the drive connection to the chuck. By doing this, screws can be driven to a predeter- mined depth, which is ideal for repetitive work.
jSelect a low setting for small screws, soft work material.
jSelect a high setting for large screws, hard work materials and for the extraction of screws.
jFor drilling, push the selector to the setting for drilling, in that you adjust the torque 
.
jFor drilling tasks, also push the gear selector switch 1 to the front (Position: 2).
Switching on:
jTo start the appliance squeeze on the ON / OFF switch 5 and then keep it pressed down.
Switching off:
jTo stop the appliance, release the ON / OFF switch 5 .
QAdjusting the speed
The ON / OFF switch 5 has a variable speed regulator.
jBy increasing the pressure on the ON / OFF switch 5 you can increase the R.P.M.
Note: The integrated motor brake ensures the shaft quickly stops rotating - so that you can get to work again fast.
Q2 Gear Drive
mCAUTION! Move the gear selector switch 1 only after the device has come to a standstill. Failure to observe this advice may result in damage to the device.
In the first gear (Gear selector switch 1 in Position: 1)
A speed of up to approx. 500 rpm can be achieved and a high torque. This setting is intended for use with all screwing tasks and for accessories.
In the second gear (Gear selector switch 1 in Position: 2)
It achieves a speed of up to approx. 1400 rpm, for the carrying out of drilling tasks.
QPreparing the tool for use
QSwitching On /Off
mCAUTION! Make sure the device not operat- ing when it contacts the screw. A rotating inserted tool may slip. This could result in personal injury or damage to the workpiece.
12 GB/IE/CY
QSwitching direction of rotation
jTo switch the direction of rotation, push the direction of rotation switch 4 to either the right or to the left.
QTips and Tricks
When screwing into wood, metal and other materials, take note of the following advice:
jBefore you use the appliance, check to see that the screw or drill bit is properly fitted, i.e. located centrally in the chuck.
jScrew bits are designated with their dimensions and their shape. If you are unsure, always try the particular screw bit out to see whether it sits in the screw head without any free play.
Torque:
jSmaller screws and bits in particular can be easily damaged if you adjust the appliance with too high a torque and/or rotation speed.
