Lincoln Electric 500 manual COMMANDER / K867 / K775 / LN-7CONNECTION DIAGRAM

COMMANDER / K867 / K775 / LN-7 CONNECTION DIAGRAM

	WARNING
Do not operate with panels open.	Keep guards in place.
Disconnect NEGATIVE (-) BATTERY LEAD	Keep away from moving parts.
before servicing.	Only qualified personnel should install,use
Do not touch electrically live parts.	or service this equipment.

F-3

VANTAGE 500 CUMMINS

14PIN AMPHENOL

ELECTRODE TO WORK

K867 UNIVERSAL

ADAPTER PLUG

TO WORK

ELECTRODE CABLE

TO WIRE FEED UNIT

CAUTION :

SPARE	}
41
82
81		N.D.
42
31		31
32		32
2		2
4		4
21		21
GND		GND
		GREEN
75		75
76		76
77	}	77

N.E.

LN-7

WIRE

FEEDER

K291 OR K404

INPUT CABLE

K775 OPTIONAL REMOTE CONTROL

CONNECTION DIAGRAMS

ANY INCREASE OF THE HIGH IDLE ENGINE RPM BY CHANGING THE GOVERNOR SETTING OR OVERRIDING THE THROTTLE LINKAGE WILL CAUSE

AN INCREASE IN THE THE AC AUXILIARY VOLTAGE. IF THIS VOLTAGE GOES OVER 140 VOLTS, WIRE FEEDER CONTROL CIRCUITS MAY BE

DAMAGED. THE ENGINE GOVERNOR SETTING IS PRE-SET AT THE FACTORY - DO NOT ADJUST ABOVE RPM SPECIFICATIONS LISTED IN

THE ENGINE WELDER OPERATING MANUAL.

N.A. WELDING CABLE MUST BE OF PROPER CAPACITY FOR THE CURRENT AND DUTY CYCLE OF IMMEDIATE AND FUTURE

APPILICATIONS. SEE OPERATING MANUAL.

N.B. USE VOLTMETER SWITCH TO SELECT DESIRED ELECTRODE POLARITY. POSITION THE "SELECTOR" SWITCH TO "WIRE WELDING CV".

PLACE WIRE FEEDER SWITCH TO "WIRE FEEDER WITH CONTROL CABLE POSITION.

N.C. IF OPTIONAL REMOTE OUTPUT CONTROL IS USED,CONTROL IS AUTOMATICALLY SWITCHED TO REMOTE CONTROL.

N.D. INSULATE EACH UNUSED LEAD INDIVIDUALLY.

N.E. SPLICE LEADS AND INSULATE.

7-2000

S23983

F-3