
Introduction
improper usage. The appliance is not intended for commercial use.
QEquipment Components
1Gear selector switch
2Spirit level
3Button - Battery condition / Battery display LED
4Direction of rotation switch / lock
5ON / OFF Switch / R.P.M. regulator
6Bit storage
7Button for battery release
8Battery pack
9Torque
10Drill chuck
11Fast charger
12Green
13Red
QItems supplied
1 Cordless Drill / Screwdriver X18V with battery pack
2 Double bits
1 Fast charger
1 Storage bag
1 Operating manual
1 Booklet “Warranty and Service”
QTechnical Data
X18V 2 Speed Cordless Drill / Screwdriver / KH3188:
Nominal
Nominal
Nominal voltage:
Chuck size:
Maximum Drill Diameter:
Wood:
Variable torque levels:
Max. Torque:
X18V Battery Pack / KH3191:
Nominal voltage: 18 V
Capacity:1,5 Ah
Energy content: | 27 Wh | ||
X18V Fast Battery Charger / KH3192: | |||
Primary: |
|
|
|
Nominal voltage: | 230 V ~ 50 Hz | ||
Nominal output: | 60 W | ||
Secondary: |
|
|
|
Nominal voltage: | 18 V |
|
|
| |||
Charging current | 2600 mA | ||
Charging time: | approx. 60 min | ||
Protection class: | II / & |
Noise / vibration data:
Values determined in accordance with EN 60745 The sound pressure level
The sound level while working can exceed 77 dB (A).
Wear ear protection!
Total vibration (vector sum of three directions) is calculated in accordance with EN 60745:
Drilling in metal: | Vibration emission value |
| ah, D= 1.944 m / s2, |
| uncertainty K= 1.5 m / s2, |
Screwing: | Vibration emission value |
| ah= 2.101 m / s2, |
| uncertainty K= 1.5 m / s2. |
Warning! The vibration level given in these instructions has been measured in accordance with a standardised measurement procedure specified in EN 60745 and can be used to compare devices. Different uses of the device give rise to different vibration levels and in many cases they may exceed the values given in these instructions. It is easy to underestimate the vibration load if the electrical power tool is used regularly in particular circum- stances.
Note: If you wish to make an accurate assessment of the vibration loads experienced during a particular period of working, you should also take into account
GB/IE/CY 7