Paper
10
10-4 bizhub 164
10.1
10.1.2 Loading paper
This section describes how to load paper into each paper tray.
If printing stops due to the paper tray being empty, load paper into the paper tray. For the types of paper to
be used, refer to page12-3.
Loading paper in Tray 1
0Make sure that the original and the loaded paper have the same orientation. Otherwise, some parts of
the image may be lost.
1Pull out Tray 1.
2Press down on the Paper-Lifting Plate until it locks into place.
%1. Paper Take-Up Roller
NOTICE
Be careful not to touch the Paper Take-Up Roller.
3Slide the Lateral Guides to fit the size of paper being loaded.
%To load the custom size, load the paper, then adjust the Lat-
eral Guides to the size of the paper being loaded.
4Load the paper into the paper tray so that the side of the paper to
be printed on (the side facing up when the package was un-
wrapped) faces up.
%Do not load so many sheets of paper that the top of the stack
is higher than the , mark.
%If paper is curled, flatten it before loading it.
%Allows you to load up to 250 sheets of plain paper, or 20
sheets of card in the paper tray.
5Close Tray 1.
6Press the Start key to restart printing.
1