TITLE IMPRINTING

Filmstrip Title Imprinting

You can choose a title for the entire roll of film. Both the filmstrip title and the frame title will be imprinted on the back of the photograph.

• The filmstrip title will be imprinted on the back of every print.

After the film has been rewound and is blinks in the data panel-

1. Open the control-panel door and press the title button to select the desired title.

• Each press of the title button changes the title to the next selection.

2. Press the shutter-release button all-the-way down to set the title.

3.When blinks in the data panel again, press the film-chamber release and remove the film.

•Set the filmstrip title before removing the film. Once the film has been removed, a filmstrip title can not be recorded.

•Once set, the filmstrip title can not be changed or canceled using the camera.

•Filmstrip titles set on rolls rewound at mid roll will appear on frames exposed after reloading.

•A filmstrip title can not be set on a reloaded partially exposed roll.

SELF-TIMER

The self-timer will delays the release of the shutter for approximately 10 seconds after the shutter-release button is pressed.

1. Place the camera on a tripod, then press the self- timer button, until appears in the data panel.

2. Center your subject in the focus frame.

3. Press the shutter-release button all-the-way down to start the timer. The self- timer indicator on the front of the camera will blink, then glow just before the shutter releases.

•The self-timer mode will automatically cancel after the shutter is released.

•Do not press the shutter-release button while standing in front of the camera.

•If you want to take a picture with your subject outside of the focus frame, use focus hold. See page 38.

•To cancel the self-timer before the shutter releases, press the main switch to turn the camera off, or press the self-timer button.

74

75